Chimney Services in Andover, Massachusetts

Around 17% of homes here heat with oil, and oil soot is acidic. It attacks flue tile and the mortar between tiles from the inside, where a look from the roof will not find it. That is the case for a camera survey rather than a visual inspection. It also matters if you ever convert to gas: the flue will then be far too large for the new appliance and will need relining.

Less urgently, but yes. An uncapped disused flue collects rain, leaves and nesting for years with nobody noticing, and water sitting inside it damages the structure from within. If the chimney is genuinely finished with, removing it above the roofline and roofing over is a legitimate option. If anything at all still vents into it — a water heater in particular — then it matters as much as it ever did.

Galvanised caps and chase covers corroding through within a few years near the water. That pattern is regional rather than universal — salem, Lynn, Beverly, Gloucester, Lawrence and Haverhill. It is worth knowing before you book, because it tells you what someone should be looking hardest at here.

It depends entirely on what the chimney turns out to need, and the spread is wide. Sweeping, an inspection, a cap or a damper repair are the inexpensive end and are usually done in one visit. Relining, rebuilding above the roofline and full crown recasting are the expensive end. Nobody can quote it honestly over the phone, which is why the inspection comes first. The contractor you are introduced to sets their own prices and agrees them with you directly.

Yes — all 5 ZIP codes in Andover and the surrounding towns. Tell us where you are and we put you in touch with a company that covers it.

For a routine inspection or sweep, usually within a few days, and sooner outside the fall rush. Late spring through early fall is the quiet season and the easiest time to book. If you have had a chimney fire, or you can smell gas or have a carbon monoxide alarm sounding, that is not a scheduling question — leave the building and call emergency services from outside.

Several possible causes, and they need different work. A blocked cap or arrestor, a damper not opening fully, a smoke chamber that was never parged, a flue too small for the fireplace opening, or a chimney too short relative to the roof around it. A house sealed tight enough to run under negative pressure will also pull air down the flue. An inspection separates them; guessing does not.

It depends how far the damage goes. If a key scrapes mortar out but the brick is intact, that is repointing. Once brick faces have flaked through, a brick can be rocked by hand, or the stack leans, repointing has nothing sound to bond to and a rebuild is the honest answer. Most rebuilds stop at the roofline, because that is the section taking weather from every side.

We charge nothing at any point — contractors pay us, you never do. What a company charges to attend or to carry out an inspection is theirs to set, so agree it with them before they come out. An inspection is a real piece of work with a written report attached, and it is reasonable for it to be chargeable.

Annually, whatever it vents — that is the NFPA 211 standard and it covers gas and oil appliances as well as wood. Sweeping frequency is separate and depends on what and how much you burn. An appliance used twice a year still needs the annual look, and those are the ones where neglected faults turn up.